Wencon® Fixation Tools

WENCON Fixation Tools

Fixation tools for repair of cracks and corrosions in tanks, leaking pittings and welding seams. The Fixation Tools helps to support and secure WENCON products to the damaged part and can be used with most WENCON products.

The WENCON Fixation tools contains:

  • 4 x Anchor bolts
  • 8 x M6 Hexagon nuts Din 934
  • 8 x M6 Washers Din 125A
  • 4 x M6 Plain Washers Din 9021
  • 2 x Fixation plates flat 250mm length
  • 2 x Fixation plates angled 250mm length
  • 1 x Metal drill bit 6.0mm Din 338N HSSG

How to use the Fixation Tools with a crack:

Drill the cracks in both ends with a 6.0mm drill bit, to prevent the crack from running. Make corresponding holes in the fixation plate and push the anchor bolts through the plate and the holes, making sure that the anchor hooks up on the backside of the wall (check to pull the anchor bolt back, which must be impossible). Apply the Wencon product between the fixation plate and the wall and tighten it using washers and nuts.

The same procedure goes for the angled fixation plate, which is intended for support on leaking welding seams.

The Wencon Fixation Tools can be ordered as article number 2808